AKG IVM 1 Spécifications Page 20

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 39
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 19
4 Advanced Functions
«
44..22..55 IInnffoo
Refer to fig. A26
on page 136.
55..11 TTrraannssmmiitttteerr aanndd
RReecceeiivveerr
55..22 EEaarrbbuuddss
You can call up the following details about your transmitter in this order:
- Firmware version (e.g., "F 2.30")
- Frequency band (e.g., "B 7.A5")
- Preset version (e.g., "P 1.76")
To clean the transmitter and receiver surfaces, use a soft cloth moistened with
water.
1. Use a soft cloth moistened with water to clean the earbud surfaces.
2. To prevent infections, clean the ear molds with a skin compatible antiseptic be-
fore and after use.
39
AKG IVM 4
5 Cleaning
6 Troubleshooting
Probelm Possible Cause Remedy
No sound. 1. Power supply is not connected
to transmitter and/or power
outlet.
2. Transmitter/receiver is OFF.
3. Transmitter is not connected to
mixer.
4. Transmitter is tuned to different
frequency than receiver.
5. Receiver batteries are not in-
serted properly.
6. Receiver batteries/battery pack
dead.
7. Transmitter is too far away from
receiver or squelch threshold
setting is too high.
8. Obstructions between transmit-
ter and receiver.
9. Transmitter too close to metal
objects.
1. Connect power supply to trans-
mitter and/or power outlet.
2. Switch transmitter/receiver ON.
3. Connect mixer output to trans-
mitter input.
4. Tune transmitter and receiver to
same frequency.
5. Insert batteries conforming to
"+" and "-" marks.
6. Replace batteries/charge bat-
tery pack.
7. Move closer to transmitter or
choose lower squelch threshold
setting.
8. Remove obstructions.
9. Remove objects or place trans-
mitter further away.
Noise, crackling, unwanted signals. 1. Antenna location.
2. Interference from other wireless
systems, TV, radio, CB radios,
or defective electrical appli-
ances or installations.
1. Relocate transmitter or an-
tenna.
2. Switch off interference sources
or defective appliances or tune
transmitter and receiver to a dif-
ferent frequency; have electrical
installation checked.
Distortion. Interference from other wireless
systems, TV, radio, CB radios,
or defective electrical appli-
ances or installations.
Switch off interference sources
or defective appliances or tune
transmitter and receiver to a dif-
ferent frequency; have electrical
installation checked.
Momentary loss of sound
("dropouts") at some spots
within performance area.
Antenna location. Relocate transmitter or an-
tenna. If dead spots persist,
mark and avoid them.
IVM4_Hex_final_XP7:Layout 1 2/27/07 11:26 AM Seite 39 (Schwarz/Black Auszug)
Vue de la page 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 38 39

Commentaires sur ces manuels

Pas de commentaire