AKG AKGP820 Manuel de service télécharger pdf (Page 28)

28 P820

Operation

 To switch the filter in, set the bass cut filter switch on the Remote

Control Unit front panel to the " " position.

 To switch the filter out of circuit, set the bass cut filter switch on the

Remote Control Unit front panel to the " " position.

Each of the P820 TUBE's selectable polar patterns is virtually frequency

independent so that reflected sound, too will be reproduced accurately and

uncolored.

 Cardioid (center setting): This is a standard setting for recording and

gives excellent results on all kinds of voices and a wide range of

instruments. Remember to aim the microphone front at the sound source.

 Figure eight (right-hand setting): The microphone will pick up sounds

arriving from the front and rear with equal sensitivity. Use this mode to mic

up the side signal in M/S stereo recording or to record two sound sources

(talkers, instruments) facing each other. It is also a good choice for cymbal

overhead miking.

 Omnidirectional (left-hand setting): This is the preferred setting for "all

around the mic" recording, high quality ambience (audience sound) miking,

or far-field recording in exceptionally good-sounding large or small

recording rooms, etc.

Selecting Polar Patterns

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 67 68

Pas de commentaire

AKG AKGP820 Manuel de service Page 28